Indoor/Outdoor Plenum Premises Distribution (PDP-I/O, ICP-I/O)

This fiber optic cable is designed for installation in plenum, riser  and horizontal environments and interbuilding backbone structures.

This design incorporates tight buffered optical fibers within a dry water blocked cable core.  Suitable for operation across wide temperature variations typically addressed by outside plant cables.  No Buffer Tube Fanout kits are required.  Direct termination is enabled.

Construction

Each cable utilizes our DryGel water blocking system in the cable core.  Cable design can accommodate from 2-144 tight buffered (900 µm) fibers.  All dielectric.

Interlocking Armor (Armor-Tek) versions are available using aluminum or steel armor.

Outdoor Considerations

These water-blocked cables feature fungus resistant jacketing, and are sunlight resistant per UL 444 clause 7.22.

For use in conduit, below the frost line.

Loose Tube cables are recommended if interbuilding conduit systems lie above the frost line and are likely to fill with water.

•  Tight Buffer fiber cables are not suitible for aerial-lashed installations.

Applications

Berk-Tek's tight buffered cable is intended for all high speed data applications including:

• ETHERNET: 10BASE – 400GBASE (10BASE, 100BASE, 1000BASE, 10GBASE, 40GBASE, 100GBASE, 400GBASE)
• Fibre Channel: 1G-FC – 128GFC (1, 2, 4, 8, 16, 32, 128 GFC)
• SONET: OC-1 – OC-768 (OC -1, 3, 12, 24, 48, 192, 768)
• SDH: STM-0 – STM-256 (STM-0, 1, 4, 16, 64, 256)
• OTN: OTU-1 – OTU4 (OTU1, 2, 2e, 2f, 3, 3e2, 4)
• CPRI: CPRI-1 – CPRI-9 (CPRI-1, 2, 3, 4, 5, 6, 7, 7a, 8, 9)
• PON (SMF ONLY): RFoG, APON, BPON, EPON, GPON, WDM-PON, NG-PON

Features

• Flexible, small diameter, 900 µm tight buffered construction
• High tensile strength and small diameter design
• 2 to 144 count fiber construction plenum designs ideal for horizontal and backbone installation
• Single-mode, multimode, and hybrid designs available
• Also available in low smoke zero halogen design

Benefits

• Cost-saving design, easy to install and terminate
• Provides for greater pulling distances thus reducing installation time
• Assurance that cables will meet required specifications for communication networking applications
• Broad design selection allows for mix and match of fiber components to specific networking applications
• One cable design meeting all structured cabling network communications applications